The wiring method is as follows:
1. Remove 6-8 mm of insulation from the wire, then insert the exposed wire into the terminal, tighten the screw at the end with a screwdriver, and then pull it by hand to confirm that the wire and the terminal are firmly engaged, then Press the switch, when the terminal wiring is lit, it means that the terminal wiring has been completed.
2. The terminal block is a connector for connecting wires. It is a metal sheet sealed in plastic. There is a hole at both ends of the metal sheet. The wire can be inserted and then fixed with screws, or loose Open, like two wires, sometimes connected and sometimes separated, so that they can be connected together with a single terminal without soldering or tangling.
3. When connecting, it should be ensured that it is strictly forbidden to be electrified before the power is cut off. In the case of uncertain power failure, an electric pen or a multimeter can be used to measure. When the wire is connected, if there is a slip on the terminal or switch end, it should be replaced in time to avoid electric shock.
Extension: When supplying power, be sure to use PVC cables, don't pull the wires casually, and when installing, be sure to install a hanger at the corner of the pipe, so that the cables can be better fixed, don't put the wires on the hanger on the rod.